MyBinding Standard 3030x Manual de instrucciones descargar pdf (Pagina 18)

5.0 Installation & Setup

5.8 Power Hook-Up

SHOCK HAZARD! NEVER CUT THE GROUND PLUG from a three-prong

plug to fit a two-prong socket. Possible shock could cause personal injury or death. Hire a qualified

electrician to provide a power source that meets electrical requirements and all local electrical codes.

It is the customer’s responsibility to provide a properly grounded receptacle that meets the power

requirements specified on the nameplate of this machine, as well as all local electrical codes. Have a

qualified electrician install one if your location is not so equipped.

Check incoming voltage and position the voltage selection jumper in the proper location as shown

below:

NOTE: The terminal block jumper must be set to the correct location according to the supply voltage

of the machine. Failure to set the terminal block jumper will cause damage to the machine!

Connect the power cord into a grounded, 3-prong receptacle only! (Recommended receptacle: 208-

230 Volt, NEMA 6-15R, or NEMA 6-20R.)

Figure 14

5.9 Line Light

The Titan 200 is equipped with two lights, which provide a line of light on the paper in the

approximate location of where the paper will be cut. The lights come on when power to the machine

is turned on. The light from each bulb reaches the table after passing between the knife and clamp.

Each light is focused with a socket head capscrew (Figure 15 on page 18).

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 77 78

Sin comentarios

MyBinding Standard 3030x Manual de instrucciones Pagina 18