MyBinding Standard 3030x Manual de instrucciones descargar pdf (Pagina 27)

6.0 Operation

this feature off. It is recommended that this feature be left on whenever possible. In the push-out

screen, use the up and down arrow keys to toggle to the on or off status as desired, and press

ENTER.

6.12.2.4 Accuracy Adjust

This parameter provides a means for adjusting the accuracy of the backgauge. To change the

accuracy, send the backgauge to 2 inches (50.8mm) and cut some paper. Measure the paper, and

type in what you actually measure. The computer will calculate the amount of error and will

compensate.

6.12.2.5 Knife Count

The knife count parameter allows the operator to reset the knife alarm and the lube alarm. The knife

alarm displays a message that notifies the operator to change the knife. The lube alarm displays a

message that notifies the operator to have the machine lubricated. The lube alarm will also display

the name and phone number of the Challenge dealer from which the machine was purchased.

NOTE: The alarms do not prevent normal operation they are simply reminders.

There are three functions within the knife count parameter: Clear Count, Knife Alarm, and Clear

Lube. Select the desired function and press ENTER. See the following descriptions for an

explanation of each function.

Select Clear count to reset the knife counter when a knife change has been performed.

Select Knife Alarm to enter or change the knife stroke alarm value. When this value is reached, the

display will alert you to change the knife and reset the knife counter. Knife alarm values for the Titan

200 are factory set at 2,500 cuts. However, you may want to change this value based on your

specific machine applications. See 7.3 Knife Care Tips, page 37 for help in choosing a knife alarm

value for your machine.

Select Clear lube to reset the lube alarm after performing the lubrication requirements as shown in

8.3 Oil and Grease, page 42. Note: The number of cuts needed to set off the alarm is programmed

at the factory and cannot be changed.

6.12.2.6 Machine count

The number displayed is the total number of cuts made by the machine.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 77 78

Sin comentarios

MyBinding Standard 3030x Manual de instrucciones Pagina 27