MyBinding Standard 3030x Manual de instrucciones descargar pdf (Pagina 30)

6.0 Operation

simply press ENTER again to begin entering send values (see below). To name the job, press the

right arrow key to move the cursor to the first character position. Enter a character of the alphabet by

using the up and down arrow keys to toggle to the desired character. The numeric keys can be used

to enter numbers directly into the job name. When the desired character is in place, use the right

arrow key to move to the next character position. The job name can be up to 10 characters long. A

letter can be removed from the job name by moving the cursor to the undesired character and

pressing the CLEAR key. When finished, press ENTER to save the name and to begin entering send

values. The screen should now look similar to the one shown next:

5.000in # 1

1> _

A) Insert C) Erase

B) Job D) Exit

6.13.4.1 Entering Send Values

Now enter send values by using any of the following methods: 1) Type in the desired value and press

ENTER, 2) Press ENTER at a blank line - this will enter the current position of the backgauge as a

send value, or 3) Use the “Cut and Record” feature as described below.

When finished entering send values you may exit the current job by pressing soft-key “B” (Job) to go

back to the job mode screen or soft-key “D” (Exit) to exit to send mode. Or you may use the current

job for cutting by pressing the down arrow at the last line and following the instructions in the

“Running a Job” section (page 30).

6.13.4.2 Cut and Record

To use this feature, send the backgauge to a desired position using the backgauge glide control or by

using SEND, then make a cut. The current backgauge position will automatically be entered into the

job as a send value. This can be very convenient for setting up a program when the actual cut

positions are not known.

6.13.4.3 Channel Linking

If more than 99 cut values are needed, 2 channels can be linked together into one job providing up to

198 cut values. This is done automatically when a job is at 99 cuts and an attempt is made to add

another value. At this point, a screen is displayed asking: do you want to link to the next channel?

Use the up or down arrow key to select yes or no. If no is selected, the last cut will be discarded and

the new value will be inserted. If yes is selected, the last cut will be pushed into the first value of the

next channel, although it will be displayed as value 100 of the current channel. If the next channel is

locked, linking will not be allowed. NOTE: If the next channel is not locked, but contains data, the old

data WILL BE LOST. After 2 jobs have been linked, the linked job will be displayed as “^^^^^^^^” and

will be locked.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 77 78

Sin comentarios

MyBinding Standard 3030x Manual de instrucciones Pagina 30